I believe Vishay's ±0.2ppm/°C TCR is a materials science process specific to one of the companies they own, so that is also a reason they can charge quite high prices.
If you don't need that kind of TCR (i.e. your part is not going to space) the price should go down considerably for a thin film NiCr resistor (5 ppm - 25 ppm). There is actually a lot more direct sales and custom design volume than I would have expected when I started in this industry, so what you see on Digi-Key is not the entire market.
The resistors are manufactured so that they are "guaranteed by manufacturing" such that the outliers are 1%, 5%, 10%, etc. And they do statistical checks on batches, but not really looking for the 10% outlier (which is stupendously rare and very difficult to catch) but looking for slight drifts off nominal (which are much easier to spot) which would result in more outliers than expected.
As such, if you measure resistors, you tend to find that you get really close to nominal--much closer than you would expect for 10%, say. Resistors are so cheap that binning simply doesn't make economic sense.
There are all kinds of crazy parameter variations in optoelectronics. I understand that resistors are really close to nominal because the manufacturer's ability to tune the process controls are so much better than the standard 5% and 10% bins, but it seems that LED manufacturing is way more difficult and they can't always tune the process to get exactly what they want.
if your temperature range is -40° to 85° and your resistance is +0.9% off nominal when measured at 22°, your temperature coefficient of resistance would need to be under +16 ppm/° to ensure that it was still below 1% even at 85°. a more typical tcr for ±5% thick-film resistors is +250ppm/° (see, e.g., https://www.vishay.com/docs/51058/d2to35.pdf) and so there is no hope of binning such a resistor as a 1% one
aging is another source of component value error that can prevent binning (the component value drifts over time, usually proportional to the square root of its age), and some kinds of resistors also have a significant voltage coefficient of resistance (mostly semiconductor types like carbon-film and the antediluvian carbon composition)
these phenomena sometimes lead designers to use expensive tight-tolerance resistors (±0.01% nowadays, 50¢–250¢ each) even in circuits that can easily be calibrated to handle component value error, just to keep the calibration from going off due to temperature or aging and to improve linearity
disclaimer: i'm not an electrical engineer, i just play one in ngspice
