The concentrator mirrors had to be aimed within about 2 degrees to aim the light onto the active area of the cells. I tried using a pair of photodiodes as the sensor, and it worked well in early prototypes. We flew out to Australia before the system was fully integrated into the car, though. In the real setup it just wasn't precise enough. On top of that, the aerodynamically shaped acrylic window surfaces created weird refractions and reflections that made the accuracy poor as well.
I had a couple weeks to figure something out, with a bunch of PIC18F4680 MCUs on hand, and access to parts from Dick Smith's. I ended up buying a small PAL security camera to experiment with. I went to a nearby photo center and got some overexposed film negative to use as an IR-passing filter. With enough layers of film, the camera image was completely black other than a white dot when pointed at the sun. Looking at the analog video signal on a scope, I was able to rig up a couple fine-tuneable voltage dividers and then use the MCU's dual comparator peripheral to generate interrupts on sync pulses and on white pixels. I could then count scan lines, and detect scan lines with the sun in them, giving me a Y coordinate precise to a fraction of a degree. I also got an X coordinate by timing between syncs and white pixels, but I didn't need it for control. I then mounted the camera on the concentrator mechanism, and wrote a basic PID controller.
It worked pretty well, and we were able to happily concentrate sunlight while driving at highway speeds.
It turned out the linear servo mechanism had a design flaw, where it would lose too much mechanical advantage at the extremes, and in the presence of road vibrations it would jam. We discovered this fairly early on in the race. Luckily I had wireless control of the motor over our telemetry system, allowing me to keep the motor from burning out. We drove a couple hours with the system jammed, taking the power hit over losing race time. Someone realized we would be driving over a "cattle grid" soon, and we had the idea to try running the motor at full torque to see if the shock would be enough to unjam the mirrors. It worked, and we suddenly started getting several hundred watts of additional power! After that day, we tied a string to the mechanism and routed it up to the driver cockpit. Whenever the mirrors got stuck after that, we simply radioed the driver and they gave the string a yank.
Just skimming their web site, range is qualified as "WLTP drive cycle". I assume that means software enforced torque and speed limits, and no one is going to want to drive with that enabled.
Using 4 independent motors implies they're using in-hub motors. They don't seem to mention a top speed anywhere. Unless their motors have dynamically adjustable air gaps (which I am guessing they don't), the motors will have a fixed KV constant. That means the top speed of the vehicle will be limited by battery voltage at some point. Maybe that limit is high enough not to matter, but it's funny they don't specify it.
Using in-hub motors also means there's a lot of mass on the wheels themselves. I'm not a mechanical engineer, but my understanding is that adding wheel mass makes suspension design a lot more difficult. On top of that, the rest of the car is presumably a couple hundred lb of batteries, and then a bunch of lightweight composites. The batteries will likely be in the floor, which is good for vehicle dynamics. The overall car will be significantly lighter than what people are used to. I think it's possible that the car will have a relatively rough ride, and could possibly have more noise than usual in the passenger compartment.
Crash-safety wise, I wouldn't want to drive that car on a busy highway. In the US, it would likely struggle to pass crash safety testing. I wonder if they are certifying it as a low speed vehicle, which would put it in the same regulatory class as a golf cart. It would have to have a 40kph speed limit on level ground.
It will probably cost more than a Tesla. At the end of the day, slapping a solar roof on a Tesla would probably get a lot of folk to the grocery store and back every few days. Mounting the same panels on the ground and plugging in the Tesla would be even more effective.
